6
7
English
Turn the key to the right.
Open the door.
Your electronic-lock safe communicates by means of several audio/visual signals.
Troubleshooting
Lock instructions
There are two ways to program a user code.
Press the Program button. (Prog).
Enter the Factory Code. The green LED remains ON while you
enter the 5-digit user code of your choice. After 5 digits are
entered the green LED turns OFF.
(To enter a new User Code, repeat these steps.)
–OR–
Press the red button on inside of door (hinge side). The lock will
“beep” and the green LED will come on.
Enter a 5-digit user code.
(To enter a new User Code, repeat these steps.)
Keep your new user code secure
For your records, please copy it here:
Press the Program button.
Press it a second time.
Enter your 5-digit User Code. The green LED remains ON.
Enter the 5-digit User PIN of your choice (any combination except 00000.) After 5 digits
are entered, the green LED turns OFF.
(To enter a new User PIN, repeat these steps. To erase the User PIN, press Program twice,
enter your User Code and then enter 00000.)
If your electronic lock fails or you do not have any codes available, you may use the
override key that comes with the unit.
Using two hands, hold the keypad, thumbs down, on its left and
right sides. Push up the keypad with your thumbs, disconnect
and remove the battery holder.
Insert the skeleton key into the key hole inside the opening for
the battery.
Programming a user code
Programming a user PIN
Key override
Signals
Locking your safe
1
1
1
1
2
2
2
2
3
3
4
4
The Problem:
Why It Is Happening
The Solution:
Red (Error) LED + three
beeps indicates one of
the following
You have pressed Program key
out of sequence.
Verify the code and re-enter or
reprogram
You have entered an invalid
code or user pin.
Verify the code and re-enter or
reprogram
You have let 5 seconds or more
elapse between key presses.
Lights after three consecutive
invalid codes are input
(2-minute delay mode).
Green LED only
Comes ON after you enter
a valid code and remains lit
during the 4-second period in
which the safe can be opened.
Comes ON in the Programming
mode and remains lit until you
have finished entering a 5-digit
code.
Yellow LED only
Yellow light comes ON
Batteries need to be replaced.
The Problem:
Why It Is Happening
The Solution:
Difficulty opening and
locking safe
The difficulty in opening the
EF safe is due to the gasket
expanding from changes in
temperature, extended periods
where the safe is left opened,
or the locking bolts are bent.
Close the door and pull the
handle upward until the
handle is horizontal.
For water-resistant units,
additional pressure to the
front, left side of the door may
need to be applied prior to
rotating the handle.