4
5
English
A
Find the button located on the ceiling of the unit.
B
Press and hold the button for three seconds.
C
Press any button on the keypad to awaken your safe.
D
The keypad will flash three times and then remain on
to indicate it is ready to accept a new user code.
A
Enter a user code that is four, five or six digits long.
B
A successful programming of the user code is indicated
when the LED light flashes green three times.
When using your safe, you will ALWAYS need to press any
button on the keypad to first enable acceptance of your code.
The blue backlights will illuminate to indicate the system
is active.
Write down your user code, and keep it in a secure location.
Do not store your code within the safe.
NOTE:
The user code will not be erased when the battery power is removed.
NOTE:
If you program a four or five digit user code, then you will need to wait ten seconds until
your code is accepted. This is only valid during the setup of your safe. If you program a six
digit user code, then the light will immediately turn green.
NOTE:
A red light means you are out of sequence.
WARNING
Test your code several times before putting valuables inside.
Programmable Electronic Lock
NOTE:
Store code and keys in a secure location (other than in the safe).
NOTE:
Sentry
®
Safe offers a secure on-line location for the entry and retrieval of your code.
Go to
www.sentrysafe.com/customercare/register_your_product
and
register your safe.
NOTE:
The keypad is not numbered – this is for enhanced security.
Insert key into keyhole and turn.
Do not lock key into safe – this is an override key and will open
the safe in the event that you have lost your code.
Turn the handle to the
left
(counterclockwise).
A
Remove the battery pack cover.
B
Insert four AA alkaline batteries (do not use rechargeable
batteries or other types of non-alkaline batteries).
C
Replace the battery pack cover.
The Home Defense Center comes with a built-in code.
Test the factory code 1, 2, 3, 4, 1.
IMPORTANT
All safe models initially work with the safe code 1, 2, 3, 4, 1. It is therefore important
to reprogram your safe with a new user code you have personally selected to provide
maximum security. Please read instructions that follow.
Preparing your safe for first-time use
Programming your safe
1
3
5
1
2
4
6
2
CONFIDENTIAL
