v 1.0 010719
SEO CANmax CONVERTER – INSTALLER MANUAL
(28XXXXXX), (30XXXXXX) – PCB U355
The step-by-step installation procedure
•
register on
www.can24.pro
website to download needed connection diagrams and use the
technical support,
•
read the general description of SEO CANmax converter – description of available versions can
be found on
www.seoelectronics.pl
,
•
check if the device you have is suitable to you needs:
o
check if the communication protocol used in SEO CANmax has been implemented in
your GPS/GSM device, i.e. whether the v4.0, v2.0, v1.0, FMS SAE J1939,
o
check if outputs of SEO CANmax converter are suitable for communication with
GPS/GSM device (depending on the converter model, the following ports are available:
RS232, UART, CAN with FMS SAE J1939 extended with SEO FMS),
o
check if the device compilation supports specific vehicle and necessary parameters. If
necessary, update the software using O350 programmer device.
•
connect the GROUND cable,
•
then c 12V,
•
set a 5-digit Program number dedicated to a specific car, using the PCB button and LED (see:
setting the Program number); the Program number can also be set using the O350 programmer
device.
•
connect CAN L,
•
connect CAN H.
As part of purchased software Level, the CPU contains Programs for all declared cars of a particular
group. On a particular connection diagrams, Program numbers dedicated to specific cars and machines
are indicated.
SEO CANmax reads parameters from CAN BUS only when it is properly connected and the
transmission has been established, i.e. the LED is blinking. By default, the device is programmed to a
neutral Program number 11120.
Always connect all cables indicated on the connection diagram.
