SEPLOS MASON-135 51.2V 135AH LIFEPO4 BATTERY PACK USER MANUAL
WWW.SEPLOS.COM
9
ADS
CAN
RS485
Over voltage
protection
Blink type 1
OFF
OFF
OFF
OFF
OFF
Temperature,
over current
protection
Blink type 2
OFF
OFF
OFF
OFF
OFF
Discharge
Mode
Normal
Blink type 3
OFF
According to battery SOC status
Warning
Blink type 3
Blink type 3
Over current,
temperature,
short-circuit
protection
OFF
Solid Red
OFF
OFF
OFF
OFF
Termination
of discharge
Under voltage
protection
OFF
OFF
OFF
OFF
OFF
OFF
Termination
of discharge
ADS Switch: To setup battery address for identification, and make the communicate between
batteries, battery to inverter.
NOTE: There are 8 bit DIP switches, keep the switch on down side means ‘OFF’, turn up the switch to top side
means ‘ON’
CAN 5 communication interface: follow CAN BUS protocol, for output pack information to inverter.
One pack should be assigned as master pack. And the last 4 DIP switches (#5, #6, #7, #8) to tell
how many slave packs are followed. The firs DIP switches are used for identifying slave packs.
RS485 communication interface: RJ45 port, follow RS485 protocol. For transmitting battery pack
information between paralleled packs. The first 4 DIP switches (#1, #2, #3, #4) are used for
identifying packs’ information on software.
