5 Configuration of the Altus NR2 for RTK
5.1 Basic configuration
After successfully executing the steps in ‘Initial set up’, your Altus NR2 is ready to be
configured to receive corrections and output position data.
After each change made to the Altus NR2’s configuration while executing the steps in
the following sections the pop up will appear in the bottom right of the browser window.
If the user clicks ‘Save’, the settings are stored in the boot configuration and will be
applied again when the Altus NR2 is restarted.
The configuration mechanism is explained in detail in Section 14.1.
Figure 5-1:
The ‘save to Boot’ pop-up
24
