13
Advice
It is impossible to influence the brightness by manual
adjustments while dimming processes are running.
Manual dimming procedure adjustments can be done
only after moonrise or moonset are finished.
Cleaning
Surfaces can be cleaned carefully with a moist cloth
and some neutral detergent. Make sure no detergent
gets into the aquarium. Please unplug the power cord
before cleaning.
Maintenance
The
sera LED Digital Moonlight Timer
and the other
components included with this set cannot and do not
need to be serviced.
Safety Precautions
•
Do not pull the cable of the
sera LED Digital
Moonlight Timer
and do not expose the unit to
humidity or wet conditions. Use the unit only in-
doors. Do not operate with AC voltage!
Possible errors and solution
Error
Possible cause
Solution
Display is on, lamp is not lit
1. Is your timer connected to the correct LED tube?
Yes, check following items.
No, connect moonlight.
2. Was your timer switched off manually after the
last usage?
Press key
3. Is the timer outside the set lighting time span?
Yes, wait until the set time span begins;
or, change moonrise and moonset time.
4. Is day set to 15?
a. Wait until new moon is over
b. Change to another day
Moonlight too dark
Basic brightness set to 100%?
Press “+” key until brightness is OK (see 7.2).
Brightness level (br) set too low?
Raise brightness level (br) (see 7.1).
Moonlight too bright
Brightness level (br) set too high?
Press “-” key until brightness is OK (see 7.2).
Lower brightness level (br) (see 7.1).
Moonlight too intense
Attach silver moon foil to the tube.
Program deleted
Power supply interrupted
Maintain safe power supply.
Clock time deviates strongly after some
operation time
Is an external timer or another dimmer connected in
the circuit?
Yes, remove timer or other dimmer from the circuit.
No, contact retailer.
No cloud simulation in spite of F3 mode
Is the difference between set moonrise and moonset
less than 2 hours?
Yes. Change moonrise and moonset time. Ensure
moonlight for at least 2 hours.
No, contact retailer.
Brightness cannot be changed with the
“+” and “-”keys
Is the program currently in an automatic dimming
process (Demo Mode, e.g. moonrise and moonset)?
Yes, wait for the automatic dimming process to end.
No, contact retailer.
• The
sera LED moonlight
is made of glass and
must be handled accordingly carefully.
• The
sera LED moonlight
is water proof. However,
the power plug as well as any other current con-
ducting connections must be protected against
moisture.
• The unit must immediately be put out of service in
case of damaged plugs or cables.
• The
sera LED moonlight
is not suited for general
room lighting.
Technical Data
sera LED Digital Moonlight Timer:
Input 10 – 20 V DC
max. 3 A
Max. Output ≤ Input
IPX4
sera LED moonlight
Input 20 V DC 3 W
IP68
1 m
40 in.
energy efficiency class A
+
304043-00_sera LED Moonlight Set_INT_GBI.indd 13
20.04.2017 13:41:33
