! IMPORTANT !
IF BUILDING WALL SURFACE IS IRREGULAR, DAMAGE TO SIDE AND HEAD FRAME COVER
MATERIAL CAN OCCUR AS ANCHORING FASTENERS ARE TIGHTENED. USE SHIMS AS
REQUIRED TO COMPENSATE FOR IRREGULARITIES. TIGHTEN FRAME TO WALL CAREFULLY.
4. Attach side frames to steel supports
using ¼” bolt, spinlock nut and 1-½” fender washers (provided)
through pre-punched hole in top of steel support. If pre-punched holes don’t align due to dock offset, drill
hole in side frame as required.
5. Assemble side curtains to side frames
. Position side curtain on frame and push panel clip (pre-
inserted in side curtain) into pre-drilled hole in top front of side frame. Aluminum angle must be mounted
flush with bottom of side frame. Fasten aluminum angle to side frame with TEK screws (supplied) through
V-groove on angle and stays, and at 4” up from bottom of side frame.
