10. Connect wiper seal head frame to truck shelter head frame.
Remove banding from bottom of wiper seal
head frame. Loosen TEK screws closest to the ends of the head curtain mounting angle to provide clearance for
the wiper seal mounting angle. Slide wiper seal head frame onto mounting angles. Fasten to shelter head frame
using (6) TEK screws in a minimum of three (3) areas (center and approx. 12” from each end). Fasten TEK
screws through bottom of mounting angle into bottom wiper seal head frame. Re-tighten TEK screws in head
curtain mounting angles.
11. Mount side covers to combined head frame assembly.
Remove and save TEK screws from shelter head
frame fiberglass along top end. Remove and save TEK screws (installed in Step 5) from head frame mounting
angle and end of head frame and save. Insert 1-½” flap at top of side covers between fiberglass and steel frame
and re-install TEK screws. Fasten side cover to ends of head frame through head curtain mounting angle holes,
in two locations on back edge and two locations on front edge of side frames.
12. Assemble head curtain to head frame
. Center head curtain on head curtain mounting angle and
fasten with ¼” x 1” TEK screws through ¼” washers. All stays must be fastened to mounting angle.
Fasten curtain at each end and in two places evenly spaced over pleats.
13
.
Attach side curtain retention straps to head curtain mounting angle
. Connect between grommet
tab on top inside edge of side curtain and holes in bottom leg of head curtain mounting angle. Crimp ends
of S-hooks.
14. Attach head curtain wind straps to side frames
. Attach end of wind strap to head curtain grommet
tab. Extend strap to nearest curtain screw below the grommet tab, loosen screw and attach S-hook
behind aluminum angle and screw head. Crimp ends of S-hooks. Tighten curtain screw. (
Wind straps
must not be pulled to a higher or lower curtain screw).
