2
1.
The LED will stay off during the normal operation.
2.
When the probes come into contact with water, Water Detector will transmit alert information to the Gateway.
3.
Whenever the water level subsides, the Water Sensor will transmit an alarm restore signal and stop the alarm.
4.
After the water has subsided and the probes are no longer in contact with water, the Water Detector will send a restore
signal to the Gateway to indicate the water condition has been restored. The Water Detector then returns to Normal
Operation Mode.
If Water Detector needs to reset to factory defaulted (for example, to prepare it for joining with a home controller or security
system).
Reset to Factory Defaults
1. Open Water Detector top cover.
2. Press the tamper button for 20 seconds then release the button.
3. The Blue LED will be blinking for 3 seconds when the device is reset successfully.
4. The sensor will now be reset to factory defaults and will initiate pairing mode.
Note:
Replace Battery with CR123A only. Use of another battery may negatively impact the performance of the product.
RISK OF EXPLOSION IF BATTERY IS REPLACED
BY AN INCORRECT TYPE. DISPOSE OF USED BATTERIES ACCORDING
TO THE INSTRUCTIONS
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following
measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
To assure continued compliance, any changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate this equipment. (Example - use only shielded interface cables when connecting to
computer or peripheral devices).
FCC Radiation Exposure Statement
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This equipment should
be installed and operated with a minimum distance of 20 centimeters between the radiator and your body.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Reboot the Water Detector
Operation
Caution
FCC Statement
C
on
fiden
tial
