SZ-E(B)SW02(N) V0.4
Operation
1.
On/Off and Pairing Button
2. On/Off , Pairing and alarm LED (Green)
MANUAL Operation:
•
ON/OFF:
Press this button of the device to turn the appliance on/off.
NOTE:
The appliance will be turned Off
regardless of its previous setting.
Join / Leave Function
Auto Joining State
: A sensor that does not have a network shall search for a network that is open for joining.
1. Illuminate the LED indicator for 2 seconds to indicate a successful boot.
2. The sensor should resume scanning the next time a user-trigger occurs. This allows user interaction to cause the sensor to
resume scanning.
Joined State
: A sensor that has joined shall resume the network.
1. Illuminate the LED indicator for 2 seconds to indicate a successful boot.
2. Resume operation with the existing network.
Manual Defaulting
: Default a sensor puts it into a state where it is ready to be joined to a coordinator.
The process for manually default a sensor shall be as follows:
1. With the sensor powered down, press the button and hold it.
2. Power it up again. The sensor should illuminate the LED once all boot up/initialization tasks are complete.
3. Release the button while the LED has been illuminated (in 4 seconds).
4. The sensor shall then wipe any knowledge of the previous network and other configuration parameters and begin searching
for a new network(Auto Joining State).
Troubleshooting
If the device appears to be functioning improperly, please follow the suggested steps:
1. Confirm that the device is being supplied from a 120V power source.
2. Confirm that the device is being controlled in a proper way (local switch is ON).
3. Ensure that the appliance does not exceed 15A current.