cable (A)
cable (B)
S10
S10
S3
S3
S11
S11
www.SereneLifeHome.com
5
Use two M8x40 Hexagon Socket Oval Head Bolts (S1) and two Spring Washers (S2) to secure both Right
and Left Handlebar Support Tubes onto the Base Frame. Use two M8x16 Hexagon Socket Oval Head Bolts
(S3) to secure both Right and Left Handlebar Support Tubes onto the Base Frame. Semi-tighten all bolts
with the Allen Wrench provided.
NOTE: DO NOT FULLY TIGHTEN BOLTS IN STEP 1 UNTIL STEP 2 IS COMPLETED.
STEP 2
It is recommended to have a second person assist with this step. One person should hold the Computer
Console in place while the other person connects the cables.
Connect the Control Pad signal cable (A) from the right handlebar to the signal cable (B) on right support
tube.
Install the Handlebar Bracket onto the Right and Left Handlebar Support Tubes, use two Hexagon Socket
Oval Head Bolt M8x16 (S3), two Hexagon Socket Oval Head Bolt M8x30 (S10) and two Locknut (S11), lock
them by Spanner (S4) and Allen Wrench #5 (S5).
IMPORTANT:
•
While sliding the Handlebar Bracket onto the Right and Left Handlebar
•
Support Tubes make sure the cables are installed inside the Right Handlebar
•
Support Tube and pay attention not to pinch the cables.
STEP 3
Assemble the left and right end caps (S9) on treadmill frame, tighten by two screws (S6) with cross
screwdriver (S5).
NOW PLEASE FULLY TIGHTEN ALL BOLTS INSTALLED IN STEP 1 .
S6
S6
