3
Ver.1
20 From the back side of the panel, angle the cover and carefully pass it through the
rectangular opening.
21. Position the base of the box behind the panel and align the holes of the box with those in
the acrylic panel. Reposition the cover over the box, and secure the entire assembly to
the acrylic panel by reinstalling the 4 x M4 screws into the cover.
22. Secure the controller wires along the back centre post of the panel using tie wraps.
23. Install the next largest panel on the front side of the platform. Lift it up onto the platform
and ensure that the mounting holes in the base of the panel align with those in the
platform. (If the holes do not align, the panel is on the incorrect side). The flat side of
the acrylic panels should be on the inner side of the platform. Install the 2 x M8 bolts
from the panel side down into the platform.
24. Install the last panel on the front side of the platform, similar to the step above.
25. After the two front panels have been installed to the platform, join both of the front
panels together by installing 1 x
M5X65
bolt and nut near the top of the outer side of the
panel tubes.
26. Decide if the J-Bar should be located on the left or right side of the tower.
(Note
– It must be installed on the same side the ramp will be installed.) On the side
panel it is to be installed upon, remove 4 x
M6
bolts at the mounting plate locations that
are securing the side panel to the frame.
27. Position the J-Bar over the locations where the bolts were removed. Secure the J-Bar to
the tower, by re-installing 2 x
M6
bolts in the top mounting bracket and 2 x
M6
bolts in
the bottom mounting bracket.
Un-Box #2 - Ramp
28. Carefully un-package the material from Box #2 - Ramp.
29. Install the ramp. (Note
– It must be on the same side as the installed J-Bar.)
Hold the ramp vertically, rest it on the platform, and align the mounting holes in the ramp
hinge with those in the platform. Install 5 x
M6
self-tapping screws from the hinge side
down into the platform.
30. Keep the ramp tilted upwards and install the wheel guide bracket into the inner side of
the ramp. The guide wheel should be orientated down toward the hinge. Use 2 x M5
bolts and secure the guide bracket into position.
31. Connect the sensor pan connectors located on the lower back side of the platform.
Once connected, tuck the connectors and excess cable between the sensor pan and the
platform.
