05
06
HEAD LIGHT OPERATION
OVERHEAT PROTECTION
The overheat protection circuitry in your light ensures that it operates at safe temperatures to insure a
long life. Continued heat build up is the biggest enemy of LED’s and causes lower lumen output and
lifespan when operated too hot. Under proper operating conditions your LED should last 50,000+ hours.
(See battery info for battery lifespan)
When your light is on many factors can cause it to get too hot (inadequate airflow, mud, dirt, walking up
that hill). When this happens the circuitry in this device will automatically go into “Standard” mode. Once
the air flow over the light has improved and the running temperature is reduced the circuitry will kick the
light back into the previous mode.
PRESS
Over drive
High beam
Flashing
Standard
Low
Over drive
High beam
Standard
Low
3. Press and hold the on / off button around 1 second to turn off the light.
4. When the indicator on the battery pack (see pg.9) blinks blue battery
has 20% or less charge remaining.
PRESS
PRESS
Hold for 2 Seconds
Hold 1 sec.
Change mode
Turn off
1. Your new light has two different modes (solid beam and flashing)
Holding down the power button for 2 seconds will switch the
mode between normal and flashing. When turning on the light
the light will resume in which ever function it was on when turned off.
2. Hold the power button for 2 seconds to change into the flashing
mode. Hold for 2 seconds to cycle back to the steady functions.
