07
08
REMOTE SWITCH (Not Included)
BAT-4 BATTERY OPERATION
It is normal that the battery may reach high temperatures during charging (up to 104°F/40°C), as there
is a chemical reaction happening in the battery.
Several factors can influence the battery’s durability and lifespan: type of cell strain, the maintenance
routine, the temperature and etc.
The battery capacity may become less effective; having about 80% of its capacity after 300-500
charge/discharge cycles. The battery may have 3 years or more life span under good care.
The battery voltage and capacity decrease at low temperatures, especially near or below freezing point.
The capacity decreases 5% - 10% at freezing. Around 0°F, the capacity decreases 30%. The battery
performance will return normal when the temperature gets to 70°F/20°C.
The battery will lose around 1% of its capacity per day when you store the battery at normal room
temperature. Battery temperature should never exceed 104°F/40°C, it will lose about 5% of its capacity
per day.
Fully charge the battery before storing. When not in use, we suggest a cool and dry place for storage.
Li-Ion batteries are volatile. Failure to read or follow the instructions may result in fire, personal injury or
damage to property. Do not leave batteries unattended during charging or use. Dispose of battery pack
properly if there is any noticeable damage to casing.
Equipped with a remote switch, allows you easier
on the fly control of your light. You can mount the
switch close to the grip area of your bars so that
your hands don't have to leave the bar to change
settings. It is also mountable on your helmet for
easier to reach control.
1. Open the rubber cap on the back of the light.
2. Then plug in the controller wire.
3. Make sure it has been completely connected.
1. Put one of the ends of the hook and loop strap
around the handle bar.
2. Align to the controller button and pass through
open eyelet on switch base.
3. Pull the hook and loop ends tightly.
1. Put one end of the belt go through the helmet hole.
2. Align to the controller button and pass through.
3. Pull the hook and loop ends tightly.
* When unused, please ensure the protective cap
is closed to avoid water getting in the light body.
REMOTE SWITCH OPERATION (Optional) (Fig. 1)
REMOTE SWITCH MOUNTING (Optional) (Fig. 2)
REMOTE SWITCH HELMET MOUNTING
Fig. 1
Fig. 2
INPUT : 8.4VDC 1.5A
RATING : 7.4V 6600mAh
48.84 Whr
RATING : 3.7V 13200mAh
OUTPUT : 5.0VDC 1A
