09
10
BAT-4 BATTERY OPERATION
BAT-4 BATTERY MOUNTING
1. Thread the hook and loop strap counterclockwise through the 2 slots at the side of the battery.
The hook surface of the hook and loop strap should face the battery.
2. Place the battery on the frame where it is safe and convenient.
3. Wrap the hook and loop strap over the tube.
4. Thread the hook and loop strap through the slot on the top end of the strap itself.
5. Pull the hook and loop strap and attach it tightly and firmly.
MOUNTING THE BATTERY
BATTERY CONNECTION
1. USB Port
2. Charging Port
3. Low Battery Indicator
BATTERY OPERATION
1.
2.
3.
1. Plug S-EXT-3 or S-EXT-2 cable into charging port. Then plug into cable connected to TSL-2500 head.
2. To charge accessory using USB port, simply plug into USB port (1.).
* Make sure the cover is closed, when not in use.
* Battery will automatically stop charging when full charge is achieved.
Remove battery from charger and reinsert rubber pull tab into USB port to keep out water and dirt.
Charging
1. Carefully open rubber dust cover on top side of battery, exposing charging port.
2. Insert charging cord into charging port.
3. Plug supplied wall charger into wall outlet.
4. Charge indicator on charger will turn red when
charging and solid green when fully charged.
* Do not leave battery unattended while plugged into charger or while in use.
Low Battery Indicator
1. When the battery capacity is down to the supply limit, the Low Battery Indicator will blink red.
Charging Indicator
