31
SERIAL CABLES PCI-SWGEN3-81U PCI Switch Board User’s Manual
• setalarm Command
This command is for set event alarm setting of the
PCIe switch board
.
Syntax
Usage: setalarm [Event No.] [on/off]
There are 6 events of PCIe switch board.
1.
switch chip temperature over temperature
2.
switch chip fan failure (fan speed is 0)
3.
system fan failure (fan speed 0)
4.
12V voltage over or under voltage
5.
1.8V voltage over or under voltage
6.
0.9V voltage over or under voltage
Each bit corresponding to one event in this setting.
If the alarm bit is enabled, buzzer will alarm when any one of the alarm enabled event occur.
If the alarm bit is disabled, buzzer will not alarm. Only system healthy LED change from “Green”
to “Red”.
The default setting is 0x07, only event 1,2,3 are enabled.
Example: Check event alarm setting.
JBOF>setalarm
Example: Disable switch chip fan failure alarm.
JBOF>setalarm 2 off
