Serpent Natrix 748, Instruction Manual

Read this first!

- This is a highly technical hobby product, intended to be used 

  in a safe racing environment. This car is capable of speeds 

  in excess of 80 km/h or 50mph. Please follow these guidelines 

  when building and operating this model.

- Parental guidance is required when the builder/user of this car 

  is under 16.

- Follow the building instructions. If in doubt, contact your dealer 

  or importer.

- Be sure to use the proper tools when assembling the car. 

  Always exercise caution when using electric tools, knives 

  and other sharp objects.

- Be careful when using liquids like lubrication oil, fuel or glue. 

  Do not swallow.

- Follow the manufacturer’s instruction in case you experience 

  irritation after using the product.

- Be careful when operating the car. Stay away from any rotating 

  parts such as wheels, gears and transmission. Stay 

  away from motor, engine and exhaust pipe system or speedo 

  during and immediately after use, as these parts may be very 

  hot. We advise to use protective hand cloves.

- Only operate this car in a safe environment, like a 

  special racing track or a closed parking lot. Avoid using 

  this car on public roads, crowded places or near infants.

- Before operating this car, always check the mechanical 

  status of the car. Also check that the transmitter and 

  receiver frequencies correspond and are not used by 

  any other racer at the same time. 

  Check that the batteries of the transmitter and receiver

  are fully charged.

- After use, always check all the mechanics of the car. 

  We advise to clean the car immediately after use, and 

  inspect the parts for wear or fractures. Replace when 

  necessary. Do not use water, methanol, thinner or other 

  solvents to clean the car.

- Empty the fuel tank (depending on model) if needed and 

  disconnect the receiver battery.

- Store the car in a dry and heated place to avoid corro-

sion 

  of metal parts.

- Avoid using this car in wet conditions as the water will 

  cause corrosion on the metal parts and bearings and 

  these parts will cease to function properly. 

  If driven in the wet, ensure that all the electric equipment 

  is waterproofed and after use, that all moving parts are 

  dried immediately.

Length after assembly

Each step contains a variety of numbers, lines, and symbols. The numbers represent the 

order in which the parts should be assembled. The lines and symbols are described below.

Assembly path of one item into another

Group of items (within lines) should be assembled 

first

Direction the item should be moved

Glue one item to another

Press/Insert one item into another

Connect one item to another

Gap between two items

Step number; the order in which you should 

assemble the indicated parts

USING THE MANUAL

1

Apply silicone grease (Orange), 

Apply graphite grease (Grey), 

Apply threadlock (Blue), 

Apply silicone oil,