www.servware.com
800•768•5953
Image 2
Image 1
Service, Installation & Care Manual
16
02. EQUIPMENT INSTALLATION
2.11 Flue Riser Assembly
2.12 First Time Use
To assemble the flue riser and shelf on the range it is necessary to follow the following
steps:
1. Fit the flue riser on the back
(1)
to the range
(2)
.
2. Use four screws with four flat washers to fix the internal part of the flue riser on the side
of the equipment (two screws and two washers on each side), as shown in
image 1
.
Note:
For 60" models, you must also perform the fixation in the central part of the flue
riser with 2 screws
(6)
, according to
image 2
.
3. Finally, fit the shelf
(5)
to the flue riser.
To protect the equipment against possible damage caused by shock or rocking from
transportation, burners, grids and grills are secured by plastic straps. The sides, and the
waste tray have a protective PVC film. Remove any plastics, straps, or protective film from
the equipment before operating the equipment.
Before using the equipment for the first time you should clean it with a sponge, mild soap
and water. Only then will the equipment be ready for use.