-48 VDC Remote Power Manager
Operations
99
Installation and Operations Manual
Setting the local GMT offset:
The Set SNTP GMToffset command sets the offset from GMT for the date/time returned by SNTP. The offset can be
configured in whole hours between -12 and 12 hours.
NOTE:
The CDU does not support automatic adjustment for Daylight Savings Time (DST).
To set the local GMT offset:
At the Switched -48 VDC: prompt, type
set sntp gmtoffset
, followed by the offset value, and press
Enter
.
Examples
The following command sets the local GMT offset to -12:
Switched -48 VDC: set sntp gmtoffset -12<Enter>
Displaying SNTP configuration information:
The Show SNTP command displays all SNTP configuration information.
To display SNTP configuration information
At the Switched -48 VDC: prompt, type
show sntp
and press
Enter
.
Example
The following command displays the SNTP configuration information:
Switched -48 VDC: show sntp <Enter>
Date/Time:
2013-04-13 15:21:18
Primary Host: 204.152.184.72
Secondary Host: 1.pool.ntp.org
Local GMT Offset: -8
Use DST: Enabled
Start Date: 1
st
Wednesday in April
Start Time: 04:18:06
End Date: 1
st
Sunday in November
End Time: 02:00:00
UPS Administration
Creating a UPS record:
The Create UPS command adds a new UPS device to the CDU.
To create a UPS record:
At the Switched -48 VDC: prompt, type
create UPS
and press
Enter
.
At the prompt, type the corresponding number from the list of the UPS types and press
Enter
.
At the Host Name: prompt, type the UPS’s IP address or hostname and press
Enter
.
NOTE:
Both IPv4 and IPv6 formats are accepted for IP address or hostname.
Example
The following command creates a UPS record for a Toshiba UPS with the hostname “DC1Toshiba1”:
Switched -48 VDC: create ups<Enter>
UPS types:
1 –- Generic <RFC1628>
2 -- Liebert
3 -- MGE
4 -- Tripp Lite
5 -- APC
6 –- HP
7 -- Minuteman
8 -- Mitsubishi
9 -- Powerware
10 –- Toshiba
11 –- Falcon Electric
Select type(1-11): 10<Enter>
Host/IP: DC1Toshiba1<Enter>
