144
Advanced Operations
-48 VDC Remote Power Manager
Installation and Operations Manual
Changing the syslog server port:
With Syslog support enabled, the Syslog server watches and responds to requests on the default Syslog port number
514. This port number can be changed using the Set Syslog Port command.
To change the syslog port:
At the Switched -48 VDC: prompt, type
set syslog port
, followed by the port number and press
Enter
.
Example
The following changes the Syslog port number to 411:
Switched -48 VDC: set syslog port 411<Enter>
Displaying Syslog configuration information:
The Show Syslog command displays Syslog configuration information.
To display the Syslog configuration information:
At the Switched -48 VDC: prompt, type
show syslog
and press
Enter
.
Example
The following command displays the Syslog configuration information:
Switched -48 VDC: show syslog<Enter>
SYSLOG Configuration
Primary Syslog Server IP Address: 56.47.38.29
Secondary Syslog Server IP Address: 0.0.0.0
Syslog Server Port: 411
Email Command Summary
Command
Description
Set Email
Enables or disables Email notification support
Set Email SMTP Host1/Host2 Sets the SMTP Host IP address or hostname
Set Email SMTP Port
Sets the SMTP server port number
Set Email From
Sets the email ‘From’ address
Set Email PrimaryTo
Sets the primary recipient email address
Set Email SecondaryTo
Sets the secondary recipient email address
Set Email Event
Enables or disables notification of general system events
Set Email Auth
Enables or disables notification of all authentication attempts
Set Email Power
Enables or disables notification of power state change requests
Set Email Config
Enables or disables notification of configuration changes
Show Email
Displays all Email configuration information
Enabling or disabling Email notification support:
The Set Email command enables or disables Email notification support.
To enable or disable Email notification support:
At the Switched -48 VDC: prompt, type
set email
, followed by
enabled
or
disabled
and press
Enter
.
