42
Operations
-48 VDC Remote Power Manager
Installation and Operations Manual
Serial Ports
The
Configuration > Serial Ports
allows maintenance of the serial port.
NOTE:
Pass-Thru connections can only be initiated from the command line interface via a Telnet/SSH session.
A list of serial ports is displayed for viewing. To edit serial port values, click the Edit link in the Action column next
to the serial port to be configured. The configuration page displays:
Creating a descriptive serial port name:
In the Port Name field, type a descriptive name up to 24 alphanumeric characters - (ASCII 33 to 126 decimal) are allowed;
spaces are not allowed. Click
Apply.
Setting the data rate for all serial ports:
From the drop-down menu, select the serial port data rate (in bps) and click
Apply.
Setting the serial port connection timeout value:
The Serial Port Timeout Value sets the serial port inactivity timeout period. The timeout period defines the maximum
period of inactivity before automatically closing the Pass-Thru session.
The valid range for the timeout is 0 to 60 (in minutes). The default timeout is 5 minutes. Setting the timeout value to
“0” disables the timeout.
Type the timeout minutes in the Connection Timeout field and click
Apply.
Enabling or disabling serial port active signal checking:
From the DSR Check drop-down menu, select On or Off, and click
Apply.
