-48 VDC Remote Power Manager
Operations
57
Installation and Operations Manual
The
Configuration >
page allows the setup and maintenance of settings required to enable
support.
Enabling or disabling support:
Select
Enabled
or
Disabled
from the drop-down menu and click
Apply.
Setting the server address:
Enter the IP address or hostname in the Primary and/or Secondary Host field and click
Apply.
NOTE:
Both IPv4 and IPv6 formats are accepted in the Primary/Secondary Host fields.
Changing the server port:
Enter the port number in the Port field and click
Apply.
Configuring the authentication order:
Select
Remote > Local
or
Remote Only
from the drop-down menu and click
Apply.
NOTE:
It is recommended
not
to set the authentication order to Remote Only until TACACS has been fully configured and tested.
Setting the encryption key:
Enter a key and verify the new key the Encryption Key and Verify Encryption Key fields. Click
Apply.
For security, key characters are not displayed.
Configuring access levels:
Click on the
Privilege Levels
link at the bottom of the page.
Changing a access level:
Click on the
Edit
link in the Action column for the associated Privilege Level.
On the subsequent Privilege Level - Edit page, select
Admin
,
User
,
On-only, View-only, Reboot-only,
Power User
from the Access Level drop-down menu and click
Apply.
Granting or removing environmental monitoring viewing:
Click on the
Edit
link in the Action column for the associated access level.
On the subsequent Privilege Level - Edit page, select
Yes
or
No
from the Environmental Monitoring drop-
down menu and click
Apply.
NOTE:
Granting access to environmental monitoring (temperature/humidity/sensors) to a non-admin user also grants that user access to
power monitoring (outlets, infeeds, towers – all the environmental data of the CDU).
