62
Operations
-48 VDC Remote Power Manager
Installation and Operations Manual
Features
The Configuration > Features page allows the activation and maintenance of the individual features purchased
separately from Server Technology. From the Features page, you can review all activated features and activate new
features.
To activate a special feature:
In the Feature Key Value field, enter the activation key provided by Server Technology and click
Apply.
NOTE:
A restart of the CDU is required after activating new special features.
Tools
The Tools section contains access to rebooting the unit, uploading new firmware as well as resetting the unit to factory
defaults. This section is available to administrative level users only.
Ping
The Ping feature tests the ability of the CDU to contact an IP address for another Ethernet-enabled device. For LDAP
support, Ping tests the configuration of the Domain Name Server (DNS) IP address by testing for proper name
resolution.
NOTE:
Both IPv4 and IPv6 formats are accepted in the Ping Host Name/IP Address field.
Change Password
The Change Password feature allows users to change their own password.
NOTE:
An administrator can always assign a new password.
Changing a password:
Enter the current password, enter a new password and verify the new password. Click
Apply.
View Log
The View Log feature enables viewing of the internal system log. This features logs all authentication attempts, power
actions, configuration changes and other system events. The system memory stores more than 4000 entries in a
continuously aging log.
For permanent off-system log storage, the Syslog protocol is supported.
NOTE:
Only system administrators can view the system log.
Reviewing the system log:
Click on the
Previous Page
or
Next Page
link to navigate through the log.
