800-558-8722
262-628-5600
spsales@server-products.com
7
262-628-5110
Cryovac™ Hose Fitment & Pouch
Cryovac™ Hose Support Pouch
Volume Hose Fitment & Pouch
Volume Hose Support Pouch
Turn Key Clamp
Stock #’s 85883, 85885
Series 05H
REMOTE PUMPING SYSTEM
01883-REVB-021011
U
nit
i
nstallation
ALWAYS CLEAN UNIT THOROUGHLY BEFORE USE.
See Cleaning and
Safety Guidelines. For assembly and cleaning of the pump see
included PUMP INSTRUCTION MANUAL.
The installation of this unit should be performed by a qualified
technician.
1
DETERMINE WHERE THIS UNIT CAN BE SECURELY
INSTALLED.
•
Pump and pouch support can be installed on a cart or a
cabinet which can support the weight of the condiment
pouch and at a convenient height for operation of the
pump.
•
Consider the length of hose and product pouch fitment
needed to be attached to the pump, condiment pouch,
and pouch support. (Four different hose kits are
avaliable, see part list on opposite page.)
2
REFERING TO THE CUTOUT TEMPLATE included at the back of
the manual, drill holes for the mounting screws and cutout the
opening for the tower and pump assembly.
3
Secure the tower assembly to the countertop from underneath,
by threading a washer and then a nut to the four
2” threaded
studs
supplied with the unit.
4
DROP PUMP ASSEMBLY ONTO PUMP TOWER, secure by centering
over front post and tightening thumb screw at back of tower.
5
THE CRYOVAC POUCH SUPPORT CAN REMAIN FREE STANDING,
placed beneath the pump/tower assembly or hung on spools
included with the pouch support
THE VOLUME POUCH SUPPORT in designed to be freestanding
and placed under pump/tower assembly.
C
onneCting
H
ose
to
P
rodUCt
P
oUCH
6
Place condiment pouch on a counter top with pouch fitment facing
upward.
NOTE:
Hose can be connected or disconnected to pump when
installing product pouch.
7
See below for the hose with product pouch connector and product
support pouch that fit your condiment pouch.
8
For CRYOVAC™ type product pouch install piercing connector end
of hose into condiment pouch.
9
For VOLUME type product pouch, install the hinged clip connector
to the product pouch fitment.
J
Lift and place condiment pouch in product pouch support with
pouch/hose connection seated in front slot.
NOTE:
Make sure product pouch and hose fitment assembly is seated
all the way to bottom of the pouch support slot and directed downward
for best evacuation of product.
K
Reconnect hose to pump if it was removed.
C
onneCting
H
ose
& P
rodUCt
P
oUCH
to
P
UmP
L
SLIDE END OF HOSE ONTO BODY VALVE CONNECTOR ON THE
END OF THE PUMP.
M
Bring up Turn Key Clamp and firmly tighten to seal hose to Body
Valve Connector.
N
FINAL ASSEMBLED VIEW
. Depress head assembly to prime
pump and to Dispense Product.
U
nit
d
isassembly
O
LOOSEN TURN KEY CLAMP and remove hose from pump.
P
LIFT PRODUCT POUCH OUT OF SUPPORT. Remove pouch
connection.
Q
REMOVE POUCH CONNECTION END OF HOSE FROM PRODUCT
POUCH.
1
2
3
4
5
6
6
J
L
M
N
7
7
8
9
K
