Page 6
CLEANING
It is important to clean, rinse, sanitize, and fully
dry all parts regularly and properly.
• Do not place any parts of this unit under, in,
or near high heat, as this can melt the plastic.
• A general purpose, nonabrasive cleaner
may be used on hard to remove deposits.
• Do not use abrasive cleansers, scrapers,
steel pads, steel wool, or other cleaning tools that
can scratch surfaces.
• Do not use cleansing agents with high
concentrations of acid, alkaline, ammonia or chlorine.
PUMP CLEANING
RINSE
fully with clear water.
3
SANITIZE
all parts according to local sanitization
requirements. All parts in contact with food
must be sanitized.
4
AIR DRY
all parts fully.
5
Use dishwashing
soap, hot water
and nylon brush
YES!
DISASSEMBLE & CLEAN
all washable parts with soap and hot water
(See DISASSEMBLY on page 5.)
2
FLUSH & RINSE
all pump surfaces with hot water.
Place lower end of pump into container
of hot water and operate pump until all
remaining product is expelled and only hot
water is discharged.
1
Pump is dishwasher safe.
USE A SMALL NYLON BRUSH
to thoroughly clean inside discharge
tube and any confined areas.
Clean the shell and lid by hand washing only.
