4
- FORM NO. 56041955 - SOLUS 500 CSA
KNOW YOUR MACHINE
VACUUM LID
- This lid provides access into your recovery tank so that you can clean the tank. The lid must be closed before
you try to clean.
SOLUTION TANK FILL HOLE
- This is where you
fi
ll the tank with water and cleaning solution.
VACUUM HOSE BARB
- This is where you connect your vacuum hose to the machine. A tight connection is necessary to
prevent a vacuum leak which would reduce the amount of suction.
DRAIN HOSE
- This is how you empty the dirty water from your recovery tank. Place the hose over a drain, and open the
cap. When cleaning out the tank at the end of a job, simply place this hose into a drain and use clean water to rinse out the
dirt and debris from the tank.
NOTE
: be sure to close the cap tightly before using the machine again.
HANDLES
- The handles are used to move the machine. These handles allow you to tilt the machine back onto its 12” wheels
for easy maneuvering, and/or for moving on stairways.
SWITCH PLATE
- The switches are located on the rear of the machine, out of the way of water
FAN
- Removes warm air from the component compartment.
PSI GAUGE
- indicates the pump pressure. Look at the pressure while you spray.
LATCH
- The latch holds together the tank and the base compartment.
SOLUTION HOSE QUICK COUPLING
- This is where you connect the solution line that runs from the machine to the carpet
wand or hand tool.
POWER CORD RECEPTACLES
- The receptacles are where the two power cords connect to the machine.
CASTOR
- Swivel castor provides easy maneuverability.
WHEEL
- The rear wheels are 12 inches in diameter to provide superior ease of transportation and stair climbing.
HANDLES
FAN
POWER CORD
RECEPTICLES
SWITCH
PLATE
CASTOR
CIRCUIT
BREAKER
VACUUM
LID
VACUUM HOSE
BARB
PSI
GAUGE
LATCH
SOLUTION HOSE
QUICK COUPLING
12” WHEE
L
SOLUTION
TANK FILL
HOLE
DRAIN
HOSE
