53
54
T: 0333 577 7232
T: 0333 577 7232
TROUBLESHOOTING
Fault
Possible Cause
Solution
Your Washer Dryer is
vibrating
There is too much laundry in
your Washer Dryer
There is only a small amount
of laundry in your Washer
Dryer
Check that the maximum
capacity of your Washer
Dryer is not exceeded. See
pages 27 to 34 for more
information
This will not affect the
operation of your Washer
Dryer
There is excessive foam in
the detergent drawer
Too much detergent has been
used
There is excessive foam in
the detergent drawer
Press the Start/Pause button.
To stop the foam, dilute one
tablespoon of softener into
1/2 litre of water and pour
into the detergent drawer.
Press the Start/Pause button
after 5-10 mins
Only use detergents
produced for automatic
Washer Dryers
Fault
Possible Cause
Solution
The washing result is not as
expected
Your laundry is too dirty
for the programme you’ve
selected
Not enough detergent used
There is too much laundry in
your Washer Dryer
Use the information on pages
27 to 34 to select the most
appropriate programme
Use the amount of detergent
as instructed on the
packaging
Check that the maximum
capacity of your Washer
Dryer is not exceeded. See
pages 27 to 34 for more
information
There is detergent residue on
your laundry after washing
Non-dissolving particles of
some detergents may appear
on your laundry as white
spots
There is untreated oil, cream
or ointment on your laundry
Perform an extra rinse, or
clean your laundry with a
brush after it dries
Use the amount of detergent
as instructed on the
packaging in the next wash
