Sesamo DUALCORE LH100 Installation Manual Download

Page: 2 / 73

SESAMO

DUALCORE

Thank you for choosing this product. So that you get the most out of your automated system, Sesamo
recommends you  read  and follow  the  installation and usage  instructions in this manual  carefully.  This
automated system must only be installed by professional technicians, for whom this manual is intended.
Improper  installation  can  present  a  hazard  for  persons  and  objects.  The  packaging  material  (wood,
plastic, cardboard, etc.) must be disposed of properly and must be kept out of the reach of children as
they  present  a  potential  hazard.  Each  phase  of  installation  must  be  carried  out  in  accordance  with
current  regulations  and  must  in  any  case  good  working  practice  must  be  employed.  Before  beginning
installation,  ensure  that  the  product  is  intact  and  has  not  been  damaged  during  transportation  or
storage.  Before  installing  the  product,  ensure  that  all  architectonic  and  structural  elements  of  the
doorway (installation points for automated systems, fixtures, etc.) are suitable and strong enough to be
automated.  The  door  being  automated  must  have  a  smooth  opening  and  closing  action  without
resistance.  Carry  out  a  careful  risk  assessment  and  make  any  modifications  necessary  to  eliminate
crushing or shearing zones and eliminate hazards in general. Never install the product in environments
containing  flammable  gas,  vapors  or  fumes.  The  manufacturer  of  the  automated  system  is  not
responsible for failure to  observe good technical practice or specific regulations  in the construction of
fixtures to be motorized or failures of these parts. All safety devices for the automatic door (e.g.: active
infra-red sensors) must be installed in accordance with the regulations and directives in force, the risk
assessment undertaken, the type of system, use, traffic, forces and inertia in play. Always pay particular
attention to the areas that could lead to: crushing, shearing, conveying and any other hazard in general
by placing appropriate signs if necessary. Include the identification data of the motorized door on each
installation. Check that  the electrical network  to which the system is corrected is of the  right size and
has  suitable  protections  (differential  switch  and  surge  protection).  Only  use  original  spare  parts  for
maintenance or repairs. Do not tamper with or alter the internal equipment of the automated system or
the  safety  devices  present  in  the  control  CPU.  The  manufacturer  denies  any  responsibility  of  internal
parts  on  the  automated  system  are  tampered  with  or  altered  or  if  safety  devices  different  to  those
indicated by the manufacturer are used. The technician installing the automated system must provide
the person responsible for the automatic door with the user manual and any information necessary to
use the door in automatic mode and in case of emergency. Pay particular attention to the messages in
this manual identified by the hazard symbol. These may be warnings with the aim of avoiding potential
damage  to  the  equipment  or  specific  warnings  of  potential  hazards  for  the  safety  of  the  installation
technician or other personnel. This  device has been designed for the automation of sliding pedestrian
doors. Any other use is considered contrary to the use intended by the manufacturer, who will therefore
accept no liability for the consequences.

Before performing any operation on the machine, read this manual carefully and
follow the instructions, paying particular attention to the areas with the following
warnings:

DANGER:

instructions that, if not followed scrupulously, could cause dangerous
or potentially fatal situations

WARNING:

indications that could generate malfunctions if not followed
scrupulously