Maintenance:
General warnings:
Cams:
Clean front of lock with a mild damp cloth with detergent if needed.
Use only Ethanol (Ethyl Alcohol) for disinfecting.
Do not use any hard or scratching cleanser.
Do not clean with chemical materials that melt plastic (thinner, acetone, etc.)
Be careful not to spill water on lock.
Read manual before using lock.
Periodically check nuts and screws to be tightened.
Do not over-tighten nuts or screws. Do not use an electric screw gun during
installation unless equipped with a torque adjuster.The maximum torque on
the cylinder screw is 2Nm.
Set and test user and master password prior to installing the lock
Change all default passwords with your own passwords.
Common sense, but we must say it... Do not keep the passwords in the
cabinet where the lock is being installed!
It is not possible to open lock if installed and you forget the user and master
password.
Lock gives a warning beep when incorrect passwords have been entered
in repeatedly.
Not possible for front side of lock to be opened by breaking or trying to force open lock.
Use CR2450 3.0V Lithium batteries.
Remember that battery consumption is high when programs 2, 3, and 7 are active.
Two cams are included
Cams can be placed at
increments of 90 degrees
The Stop Cam (#4) in installation
instructions can be positioned for
turning the cam clockwise or
counter-clockwise
7/8” Straight
Cam 22mm
1-1/2” Straight
Cam 38mm
10
Summary of Contents for Minik 10
Page 1: ...CABINETS LOCKERS BOXES Operating manual The easy lock in every aspect ...
Page 14: ...CABINETS LOCKERS BOXES Installation The easy lock in every aspect ...
Page 17: ...Surface Mounting Semi Flush Mounting 17 ...
Page 20: ...Joint erect lock assembly measurements 22 mm axle cam 38 mm axle cam 20 ...