background image

INSTALLATION 

Mounting Bracket 

Fix the mounting bracket to a 
secure section of wall or bulk-
head, away from any direct 
source of heat, oil, water, fuel, 
etc.

 

Check that all straps are 

clear of sharp edges or contami-
nation. Two SARTs can often be 
mounted one on either side of 
the bridge wing on commercial 
vessels. 

Install the SART into the 
bracket, ensuring the 

black

 

hanging strap is located into its 
recess 

behind

 the SART (main 

label facing you). Secure the 
SART with the 

red

 Velcro fas-

tening strap. 
 

Permanent installation on 
Survival Craft (option) 

The S.701 SART from SevenStar 
Electronics has been specifically 
designed for easy installation 
into liferafts, and can be ar-
ranged for manual or automatic 
activation. Automatic activation 
can be achieved by securing the 
hanging strap and the activation 
clip to the appropriate parts of 
the liferaft. 
 

Leisure Craft Stowage (option) 

Store in a safe location where 
you can reach it easily if needed.

 

USE 

Release the 

red

 

Velcro strap, 
then pull the 
SART from the 
mounting 
bracket. Make 
your way to the 
liferaft.

 

Pull down firmly on the red 
activation clip 

to turn the 

SART ‘ON’.  The LED will 
flash slowly. When in range of 
a radar signal, the LED will 
flash rapidly. 

Pass one end of the black 
hanging strap over the top of 
the support tube, and tie the 
strap to allow the SART to 
hang in the centre of the craft. 
Alternatively, you can mount 
the SART on the telescopic 
pole if provided (option).

 

 

MAINTENENCE 

Regular Maintenance 

The SevenStar S.701 SART has 
been designed for minimal main-
tenance. Simply check it is cor-
rectly fitted into its bracket and 
that the red activating clip re-
mains in the OFF (closed) posi-
tion. If necessary, wipe the unit 
and its bracket with a plain cloth 
and a little soapy water. SOL-
VENTS MUST 

NOT

 BE USED to 

clean the unit, as damage may 
result. A SART should be tested 
annually by removing the SART 
from its bracket, pulling the red 
clip downwards, and holding the 
SART so an X-band radar set 
triggers it. The SART LED should 
flash rapidly, and the radar dis-
play should show a pattern of 
concentric rings. There are also 
specific SART testers available 
which give a more thorough test 
and printed results. 
 

Battery Replacement 

This unit contains special batter-
ies in a sealed pack, part number 

S.701B

. The battery pack is 

marked with its expiry date, 
which is usually 5 years from 
manufacture. Replacement packs 
are available from SevenStar, or 
from their appointed agents 
worldwide. Battery pack replace-
ment can be performed by any 
competent service agent, or by 
our appointed distributors (see 
web site).

 

Reviews: