6
14.
Carefully work the aluminum front panel over
all of the shafts and bushings and secure with 4x
#4-40 black cap screws as shown. Take care to
align the LED so it protrudes through the hole in the
panel
15.
Install the serrated washers and panel
nuts. Carefully snug the nuts using a
½” socket and
finger torque only
.
Leave the ratchet wrench in the
toolbox. Cover the end of the socket
with a few small bits of tape to avoid
scratching the panel.
16.
Install and align the knobs.
17.
Using the #4-
40 x 3/16” screws, attach the feet.
