massage or roller massage, can be fitted
to the mounting receptacles on the foot
pads. Roller massage is specifically
recommended for the sole area of the
feet.
An additional roller- massage unit is
located between the foot pads and can be
removed for cleaning.
- In order to enhance the massage effect, a
foot massage should be applied using
warm water. A non-foaming bath gel
may be added.
- The integral heating element located
underneath the studded foot pads
prevents the warm water from cooling
down too fast, although it is
not
designed
to heat up the water.
●
The user is recommended to refrain from
massage treatment when suffering from
phlebitis in the legs, varicose veins (if
they tend to bleed easily), swollen feet or
any pain of unknown origin. If in doubt,
consult your doctor before using the
appliance.
Control settings
0
Unit is switched off
H massage
H bubble function
H bubble fu
massage
Operation time-limit
This foot massager is designed to be
operated for a maximum of 20 minutes at a
time without interruption, after which it
must be switched off and allowed to cool
down sufficiently before being switched on
again.
Operation
- Place the foot massager on the floor in
front of a chair.
- If required, the massage inserts for foot
reflex zones can be fitted to the mounting
receptacles on the foot pads.
- Fill with warm water until the indicated
water level is reached.
- Insert the plug into the wall socket. Make
sure that the control switch is in the “0”
position.
- Seat yourself comfortably on the chair
and position your feet on the foot pads.
Do not stand on the unit.
- Select the desired function with the
control switch. The recommended
application time is 10 to 20 minutes.
- After use, set the control switch to “0”
again before removing the plug from the
wall socket.
- Empty out the water afterwards.
Cleaning and care
●
Before cleaning the appliance, ensure it is
disconnected from the power supply.
●
To avoid the risk of electric shock, do not
clean the housing of the foot-massager
with water and do not immerse it in
water.
●
Do not use abrasives or harsh cleaning
solutions.
- The inside and outside of the foot-
massager may be cleaned with a slightly
damp lint-free cloth. Use household
tissue paper to wipe dry afterwards.
Special, commercially available cleaning
agents for synthetic materials may also be
used for cleaning.
- The cover can be removed for cleaning.
Replace to the unit after cleaning,
ensuring that it locks into place.
Disposal
Do not dispose of old or defective
appliances in domestic garbage; this
should only be done through public
collection points.
Guarantee
This product is guaranteed against defects in
materials and workmanship for a period of
5
Summary of Contents for FM 7608
Page 1: ...9 3 6 7 4b 4a 8 1 5 2 6...
Page 2: ......
