SEVERIN HT 6230, Instructions For Use Manual

Hair dryer

Dear Customer

Before using the appliance, the user should 
read the following instructions carefully.

Connection to the mains supply

Th

  e hair dryer should only be connected to 

an earthed socket installed in accordance 
with the regulations.
Make sure that the supply voltage corresponds 
with the voltage marked on the rating label of 
the hair dryer. 

Models with dual-voltage selector:

Models equipped with a dual voltage switch 
can be set to diff erent supply voltages by 
using a coin or a similar object. Make sure 
that the set voltage corresponds with the 
supply voltage.
Th

  is product complies with all binding CE 

labelling directives. 

Important safety instructions

Caution:

z

  do not use the 

appliance near bath tubs, 
washbasins or any other 
receptacle containing water.  
Protect the appliance from moisture and 
splashing water and do not operate it with 
wet hands.
In the vicinity of any water source, there 

z

is a risk even when the appliance is 
switched off .  Th

 erefore, always remove 

the plug from the wall socket aft er  use, 
especially if the appliance is being used in 
a bathroom. 
Additional protection is available by fi tting 
an earth-leakage circuit-breaker with 
a rated tripping current not exceeding 
30mA into your bathroom installation. 
Please consult a qualifi ed electrician.
Electric heating appliances operate at very 

z

high temperatures. Do not touch any part 
of the appliance except the grip. Otherwise 
there is a real risk of burning.
Do not use the appliance on synthetic hair-

z

pieces or wigs, as the heat emitted might 
cause damage to the synthetic fi bres.
Make sure the air intake and outlet 

z

openings are not blocked (e.g. by fi ngers or 
hair), and that no fl uff  or fi bre particles are 
allowed to accumulate in the air intake.
A blockage in the air-fl ow system may 
cause the integral thermal safety cut-
out to switch off  the appliance. Should 
this occur, immediately disconnect the 
appliance from the mains power and allow 
suffi

  cient time for it to cool down before 

the blockage is removed and the appliance 
is switched on again.
Every time the appliance is used, the main 

z

body including the power cord as well as 
any attachment fi tted should be checked 
thoroughly for any defects. Should the 
appliance, for instance, have been dropped 
onto a hard surface, it must no longer be 
used:  even invisible damage may have 
adverse eff ects on the operational safety of 
the appliance.
To prevent damage to the power cord, 

z

do not bend or kink the cable, especially 

-

where it leaves the housing,
do not pull on the cord,

-

do not coil the power cord around the 

-

appliance.

Do not leave the appliance unattended 

z

while in use.

Always switch off  and remove the plug 

z

from the wall socket aft er use, as well as

in cases of malfunction, and

-

during cleaning.

-
When removing the plug from the wall 

z

socket, never pull on the power cord; 

always grip the plug itself.
Do not place the appliance on any surfaces 

z

sensitive to heat during or immediately 
aft er use.
Th

 is appliance is not intended for use 

z

by any person (including children) with 
reduced physical, sensory or mental 
capabilities, or lacking experience and 
knowledge, unless they have been given 
supervision or instruction concerning 
the use of the appliance by a person 



5