–
For positioning, we recommend that you tilt the unit slightly backwards. In this way, the
transport rollers can be used to move it to its intended place of installation.
–
Before it is connected to the mains, the unit must be thoroughly checked for transport damage,
including its power cord.
–
Clean the unit according to the instructions given in the
De-frosting and cleaning
section.
–
To ensure proper functioning, wait for around 2 hours before connecting the unit and switching
it on once it has been positioned.
–
When the unit is first switched on, a slight smell may be noticed. However, this will disappear
once the cooling process has begun.
Installation
The appliance should be set up in a well-ventilated, dry room.
It should be operated in an ambient temperature of 16 to 38 °C and a relative humidity of max.
70 %.
Do not use the appliance outdoors.
Ensure that the plug is accessible and can be removed from the wall socket at any time.
Do not expose the appliance to direct sunlight, and do not position it next to any heat sources
(radiators, cookers etc).
The unit must not be installed inside a cabinet, nor directly below a hanging cupboard, shelf or
similar object.
Ensure that the door can swing open to an angle of 160°.
In the case of uneven floors, the adjustable feet on the unit can be used to compensate and
ensure optimum stability.
Ventilation
Ensure that there is enough space around the unit so that the air circulation round and behind it is
not obstructed. (Rear and sides 5 cm, top 10 cm.)
Reversible door
The design provides for the door to be reversed, i.e. for right-hinged (default installation) to become
left-hinged.
Before reversing the door, place the unit on its side, ensuring that it rests on a soft, smooth, non-
damaging surface.
1. Remove the screw covers.
17
