5
(1) Valve cap
(2) Valve
insert
(3) Valve
base
FITTINGS
Illustration model Caravelle K85
1/ Models KK55, KK65: 2 moulded oarlocks total.
Models K85, K105: 4 moulded oarlocks total.
2/
Models KK55, KK65: Safety chamber with push-in valve.
All models come with a quick repair kit. Certain models also come with a pair of oars, a bag for transportation
and a pump.
ASSEMBLY INSTRUCTIONS / INFLATION
WARNING!
Do not use a sharp tool!
Any use of an air compressor will damage your product and automatically void all warranties.
For the first inflation and in order to get acquainted with your new product, inflate indoors at room temperature where the
PVC will be soft and assembly process made easier.
If it was stored at a temperature below 0°C / 32°F, leave it at 20°C / 68°F for 12 hours before unfolding. Inflate it with the
supplied bellow pump (
KK55 and KK65
) or any inflator designed for inflatable boats, rafts, pool floats, air beds, camping
mattresses, and other low pressure inflatables. These types of inflators will have a hose and adapters to fit the valves on
this product.
Choose a smooth and clean surface to unfold your boat.
1. Your boat is equipped with two different types of valves:
a) Boston valve(s)
– please see opposite figure: Unscrew the valve cap (1). Screw the
valve insert (2) onto its base (3) and check that the valve cap stays accessible.
Insert the pump hose end piece and inflate it until you will reach the required
pressure (see point 3). After inflation fit all the valve(s) cap tight (clockwise).
N.B.
:
A slight air-leak before screwing the valve(s) cap is normal.
Only the valve(s)
cap can ensure final AIR TIGHTNESS.
b) Push-in valve(s): open the cap of the valve and inflate by using the adapter of the inflator which fits the valve.
Close the valve and press it into the air chamber.
2. Inflate the boat in the order of inflation as shown on the capacity plate printed on the boat (see also figure # 1
–
numbering of the valves).
E
N
G
L
I
S
H
Handle (K85, K105)
Moulded oarlocks
1
Main chamber with
Boston valve
Fittings for SBM
electric motor
and MM3 motor
mount (K85,
K105)
All around
grab line
Moulded oarlocks
1
Safety chamber
with Boston
valve
2
1
2 floor chambers
with push-in valves
Sevytest pressure
indicator
Figure 1
3
2
Summary of Contents for Caravelle K105
