4
Mechanical installation
Shaft-mounted gear unit with TorqLOC® (customer shaft without contact shoulder)
Operating Instructions – MOVIGEAR
®
classic
37
19. Make sure that the customer shaft is seated in the counter bushing.
9007220783632139
20. Only tighten the screws of the shrink disk hand-tight and ensure that the outer
rings of the shrink disk are parallel.
9007220783634571
21. Tighten the locking screws by working round several times from one bolt to the
next (not in diametrically opposite sequence):
The exact values for the tightening torques are shown on the shrink disk.
> 0mm
9007220783637003
22. After installation, make sure the remaining gap s between the outer rings of the
shrink disks is > 0 mm.
The remaining gap between counter bushing and hollow shaft end as well as
bushing and stop ring must be > 0 mm.
25805134/EN – 07/2018
Summary of Contents for MGFAT1-DSM-C/PE
Page 2: ...SEW EURODRIVE Driving the world...
Page 123: ......
