9
Technical data and dimension sheets
Design notes for gear units with hollow shaft and key
Operating Instructions – MOVIGEAR
®
classic
100
9.12
Design notes for gear units with hollow shaft and key
INFORMATION
Always use the supplied NOCO
®
fluid for assembly. The fluid prevents contact corro-
sion and makes disassembly at a later time easier.
The key dimension L12 is defined by the customer; however, L12 must be > DK.
9.12.1
Installation
SEW‑EURODRIVE recommends 2 variants for installing the hollow shaft and key on
the input shaft of the driven machine (= customer shaft):
1. Use the provided fastening parts for installation.
2. Use the optional assembly/disassembly kit for installation.
9.12.2
1. Provided fastening parts
The following fastening parts are provided as standard:
•
Retaining screw with washer [2]
•
Retaining ring [3]
Customer shaft
[1]
Hollow shaft
[2]
Retaining screw with washer
[3]
Retaining ring
[4]
Customer shaft
[1]
Hollow shaft
25805134/EN – 07/2018
Summary of Contents for MGFAT1-DSM-C/PE
Page 2: ...SEW EURODRIVE Driving the world...
Page 123: ......
