Compact Operating Instructions – MOVIMOT® MM..D with DRS/DRE/DRP AC Motor
27
6
Important notes on startup
"Easy" Startup
6
"Easy" Startup
6.1
Important notes on startup
INFORMATION
You must comply with the general safety notes in chapter "Safety Notes" during
startup.
WARNING
Risk of crushing due to missing or defective protective covers.
Severe or fatal injuries.
• Install the protective covers of the plant according to the instructions, also see the
operating instructions of the gear unit.
• Never start up the MOVIMOT
®
drive if the protective covers are not installed.
WARNING
Electric shock caused by dangerous voltages in the connection box. Dangerous volt-
ages may still be present for up to one minute after disconnection from the power sup-
ply.
Severe or fatal injuries.
• De-energize the MOVIMOT
®
drive using a suitable cut-off device before removing
the MOVIMOT
®
inverter.
• Secure the drive against unintended re-connection to the voltage supply.
• Wait for at least 1 minute before removing the MOVIMOT
®
inverter.
WARNING
Danger of burns due to hot surfaces of the MOVIMOT
®
drive (especially the heat sink)
or external options.
Severe injuries.
• Do not touch the MOVIMOT
®
drive and external options until they have cooled
down sufficiently.
WARNING
Unit malfunction due to incorrect unit setting.
Severe or fatal injuries.
• Observe the startup instructions.
• The installation must only be carried out by qualified personnel.
• Only use settings that are consistent with the function.
INFORMATION
To ensure fault-free operation, do not disconnect or connect power or signal cables
during operation.
INFORMATION
• Remove paint protection cap from the status LED before startup.
• Remove paint protection film from the nameplates before startup.
• Observe a minimum switch-off time of 2 seconds for the line contactor K11.
0
0
I