6
Startup of MOVIMOT
®
with MLK30A in Easy mode
Supplementary notes for installation close to the motor
Compact Operating Instructions – MOVIMOT
®
MM..D with AS-Interface
53
6.6
Supplementary notes for installation close to the motor
When the MOVIMOT
®
inverter is installed close to the motor, observe the notes in the
following chapters:
6.6.1
Checking the connection type of the connected motor
Make sure that the selected connection type of the MOVIMOT
®
inverter corresponds
to that of the connected motor according to the figure below.
U1
V1
W1
W2 U2 V2
U1
V1
W1
W2 U2 V2
W
m
337879179
NOTICE: For brakemotors: Do not install brake rectifiers inside the terminal box
of the motor!
6.6.2
Motor protection
The connected motor must be equipped with a TH. SEW
‑
EURODRIVE recommends
that you wire the TH via input DI2, see the following figure.
• Input DI2 must be monitored by an external controller.
• As soon as input DI2 = "0", the external controller must switch off the drive (bit DO0
and DO1 = "0").
TH
MOVIMOT
®
24V X5: 2a,2b
X5: 1a,1b
AS-
X6: 7
AS+
X6: 8
X6: 1,2
X6: 3,4
X6: 6
X6: 5
V0
V024
DI2
DI3
1130528523
INFORMATION
When mounted close to the motor, input DI2 is no longer available for connecting ex-
ternal sensors.
21328994/EN – 11/2014
