110
Manual – MOVIPRO® SDC with DeviceNet Interface
10
Explanation of the parameters
Parameterization of MOVIPRO
®
All operating modes can be set for parameter set 1. Only operating modes without en-
coder feedback can be set for parameter set 2 (see group 1). Without new startup, the
operating mode may only be changed within a group.
P702 Motor cate-
gory
Setting range: Rotatory/Linear
This parameter is set automatically during startup. It shows the connected motor type.
Group
Parameter set 1/2
P700 Operating mode 1
P701 Operating mode 2
Unit and option
Motor
1
"VFC"
"VFC & Group"
"VFC & Hoist"
"VFC & DC braking"
"VFC & flying start function"
"V/f characteristic curve"
"V/f & DC braking"
MOVIPRO
®
SDC
DR without encoder
2
"VFC n-control"
"VFC-n-control & Group"
"VFC-n-control & Hoist"
"VFC n-control & IPOS"
MOVIPRO
®
SDC
+ encoder option
DR with incremental encoder
or HIPERFACE
®
encoder
3
"CFC"
"CFC & torque control"
"CFC & IPOS"
DR with incremental encoder
or HIPERFACE
®
encoder
4
"Servo"
"Servo & torque control"
"Servo & IPOS"
CMP with HIPERFACE
®
encoder or resolver
AUTO
0
0
I