Manual – MOVIPRO® SDC with DeviceNet Interface
21
4
Status and error messages
Installation Notes
4.4
Status and error messages
The 7-segment display informs about the status of the MOVIPRO
®
unit. In case of re-
peated malfunctions, contact the SEW Service staff.
The display of the three-digit 7-segment display shows the current status of the unit. If
several statuses or errors are active at the same time, the error with the highest priority
is displayed.
4.4.1
Unit status
The following unit statuses are possible:
Display
Description
Maintenance switch is switched off
Initialization: Trying to establish a connection to all internal compo-
nents.
This can take several minutes after a unit replacement.
The connection has been established. The statuses of the compo-
nents or the application are displayed after 3 s.
Flashing dot: Application module running
Fieldbus error
Unit waiting for DC 24 V reset
Communication error with the power section
Error in external periphery
Non-enabled application module loaded
Internal communication error