Manual – Data Matrix Positioning System PCV80A-F200-R4-V19-SEW
7
2
Preliminary information
Safety Notes
2
Safety Notes
2.1
Preliminary information
The following basic safety notes must be read carefully to prevent injury to persons and
damage to property. The operator must ensure that the basic safety notes are read and
adhered to. Make sure that persons responsible for the system and its operation, as well
as persons who work independently on the unit, have read through the operating
instructions carefully and understood them. If you are unclear about any of the informa-
tion in this documentation, or if you require further information, please contact SEW-
EURODRIVE.
The following safety notes refer primarily to the use of PCV80A. If you use other SEW
components, also refer to the safety notes for the respective components in the corre-
sponding documentation.
Please also observe the supplementary safety notes in the individual chapters of this
documentation.
2.2
Target group
Any mechanical work may only be performed by adequately qualified personnel. Quali-
fied personnel in the context of this documentation are persons familiar with the design,
mechanical installation, troubleshooting and servicing of the product who possess the
following qualifications:
• Training in mechanical engineering, e.g. as a mechanic or mechatronics technician
(final examinations must have been passed).
• They are familiar with this documentation.
Any electronic work may only be performed by adequately qualified electricians. Quali-
fied electricians in the context of this documentation are persons familiar with electrical
installation, startup, troubleshooting and servicing of the product who possess the
following qualifications:
• Training in electrical engineering, e.g. as an electrician or mechatronics technician
(final examinations must have been passed).
• They are familiar with this documentation.
In addition to that, they must be familiar with the relevant safety regulations and laws,
especially with the requirements of the performance levels according to
DIN EN ISO 13849-1 and all other standards, directives and laws specified in this
documentation. The above mentioned persons must have the authorization expressly
issued by the company to operate, program, configure, label and ground units, systems
and circuits in accordance with the standards of safety technology.
All work in further areas of transportation, storage, operation and waste disposal must
only be carried out by persons who are trained appropriately.
