-4-
METHOD OF USE
● Inspection before use
(1) Check the appearance and structure for
any abnormality.
(2) Press Self-Test switch (about 3 seconds)
to confirm all functions are working
normally.
(3) To be careful and to avoid misjudgment,
test the unit by contacting AC 110V
insulated wire with its front side to see if it
sounds and flashes.
●
Wearing
Wear the unit on the outer side of the wrist
with the sensing side facing outward, as
shown in the following figure.
※
The effect is best when the sensing side
is facing high voltage at right angles (90
degrees).
