-9-
-10-
6.MEASUREMENT
Before proceeding with measurement ,read the
safety notes.
(1)Voltage measurement
l
Insert the BLACK test lead to COM and the RED
one to the other terminal.
l
Switch to AC V range for AC voltage or DC V range
for DC Voltage.
l
Use the test lead tip to the circuit and read the
reading of display directly.
l
If the reading exceed 600V, maybe the reading
value is wrong and it is dangerous. (refer to the
safety notes)
(2)Current measurement
l
Switch to AC A range for AC current or DC A for DC
current.
l
If the initial reading of DC A is not zero, use the
DC A zero adjust shaft to adjust.
l
Make sure that the test lead is not connect to the
Terminal.
l
Press the jaw trigger to open the transformer jaws
and clamp onto one conductor only.
l
Read the display reading directly.
(3)Ohm & Diode Measurement
For ohm test
l
Switch to OHM range and make sure there is no
power in the circuit being measured.
l
Insert the BLACK lead to the COM and the RED
one to another.
l
Connect the test leads to the circuit under test and
read the display directly.
For diode test
l
Connect the test leads to the diode under test.
l
Read the forward voltage of diode directly from
display. If connect reversely, the display shows
O.L.
