126
Operating Instructions – Electronic Motor DRC.-..-DAC
8
Description of command PCB parameters
Parameters
8.3.3
Terminal assignment
Command PCB parameters \ terminal assignment \ binary outputs
Binary output
DO01
For binary output DO01, see power section parameters.
8.3.4
Unit functions
Command pcb parameters \ unit functions \ setup
Factory setting
index 8594.0
If you set this parameter to "Delivery state", all parameters that have a factory setting
and can not be set using DIP switches t1 / f2 or setpoint potentiometer f1 are reset to
their factory setting values.
For those parameters that can be set using switches t1 / f2 or setpoint potentiometer f1
during startup in "Easy mode", the setting of the mechanical setting element becomes
active when the factory setting "Delivery state" is selected.
00
I
