84
Operating Instructions – Electronic Motor DRC.-..-DAC
6
Startup with binary slave GLK30A in "Expert mode"
Startup
You will get the following or a similar result:
Adjust the setpoint n_f2 [1] until the application runs optimally, e.g. parameter
setpoint = 855 rpm.
12.Disconnect the PC from the DRC inverter.
13.Make sure the screw plug of the diagnostic interface has a seal and screw it in.
NOTICE
Loss of the ensured degree of protection if the screw plug of the diagnostic
interface is not installed or not installed correctly.
Damage to the DRC electronics cover.
• Make sure the screw plug of the diagnostic interface has a seal and screw it in.
9007202012360459
[1]
[2]
00
I
