122
Operating Instructions – Electronic Motor DRC.-..-DAC
8
Description of command PCB parameters
Parameters
AS-Interface input
bit index 9866.1,
bits 0 – 3 and
index 9756.1,
bits 6 – 7
In conjunction with AS-Interface binary slave GLK30A:
The parameters are used as AS-Interface bus monitor. They indicate the transmission
of AS-Interface bits from and to the DRC inverter.
The following table shows the assignment of the AS-Interface input bits:
In conjunction with AS-Interface double slave GLK31A:
The parameters are used as AS-Interface bus monitor. They indicate the transmission
of AS-Interface bits from and to the DRC inverter. The meaning of the AS-Interface data
bits depends on the selected function module (see chapter "Function modules").
Index
AS-Interface bit
Meaning
9866.1, bit 0
AS-Interface input bit DI0
Ready signal
9866.1, bit 1
AS-Interface input bit DI1
Automatic/manual mode
9756.1, bit 6
AS-Interface input bit DI2
Sensor output 1
9756.1, bit 7
AS-Interface input bit DI3
Sensor output 2
Index
AS-Interface bit
Meaning
9866.1, bit 0
AS-Interface input bit DI0
Depending on the selected
function module
9866.1, bit 1
AS-Interface input bit DI1
9866.1, bit 2
AS-Interface input bit DI2
9866.1, bit 3
AS-Interface input bit DI3
00
I
