76
Operating Instructions – Electronic Motor DRC.-..-DAC
6
Startup with binary slave GLK30A in "Easy mode"
Startup
6.6
Startup with binary slave GLK30A in "Easy mode"
6.6.1
Startup steps
1. It is essential that you observe the startup instructions.
2. Disconnect all components from the voltage supply and use an external disconnect-
ing device to avoid unintentional re-connection.
3. Make sure that the DRC drive unit is connected properly. Observe chapter "Electrical
Installation".
4. Activate "Easy" mode by setting DIP switch S2/1 to OFF.
NOTICE
Damage to the DIP switches caused by using unsuitable tools.
Possible damage to property.
• To set the DIP switches, use only suitable tools, such as a slotted screwdriver with
a blade width of no more than 3 mm.
• The force used for setting the DIP switches must not exceed 5 N.
5. Set the 1st speed at the setpoint potentiometer f1 (active if AS-Interface bit DO2 =
"0" ) (factory setting: about position 5).
6. Make sure the screw plug of the setpoint potentiometer f1 has a seal and screw it in.
NOTICE
Loss of the ensured degree of protection if the screw plugs of the f1 setpoint
potentiometer are not installed or not installed correctly.
Damage to the DRC electronics cover.
• Make sure the screw plug of the setpoint potentiometer has a seal and screw it in.
2442722699
2391261323
[1] Motor speed
[2] Potentiometer setting
ON
DIP
1 2 3 4
S2
DIP switch S2/1 = OFF
Easy mode
1
2
3
4
5
6
7
8
9
10
0
2000
[min
-1
]
[2]
[1]
0
1500
500
1000
6
5
f
1
00
I
