Operating Instructions – Electronic Motor DRC.-..-DAC
83
6
Startup with binary slave GLK30A in "Expert mode"
Startup
6.7.3
Example "Fine adjustment of setpoint f2 using MOVITOOLS
®
MotionStudio"
1. It is essential that you observe the startup instructions.
2. Activate Expert mode as described in chapter "Startup with binary slave GLK30A in
"Expert" mode".
3. Connect the PC to the DRC inverter.
4. Connect the DRC inverter to the voltage supply.
5. Start MOVITOOLS
®
MotionStudio.
6. Create a project and network.
7. Configure the communication channel at the PC.
8. Perform an online scan.
You will get the following or a similar result:
9. Open the context menu of the DRC command pcb [1] by clicking the right mouse
button and select the menu item "Startup" / "Parameter tree".
10.Open the folder "Setpoint selection" [3].
Deactivate switch f2 by enabling the check box "Switch f2" [4].
11.Open the folder "Setpoints" [2].
9007202012059915
[1] DRC Command pcb
[2] DRC Power section
[3] Setpoint selection folder
[4] Check box for switch f2
[4]
[3]
[1]
[2]
00
I
