Operating Instructions – Electronic Motor DRC.-..-DAC
85
6
Assigning slave address with hand-held programming device (GLK30A)
Startup
6.8
Assigning slave address with hand-held programming device (GLK30A)
Hand-held AS-Interface programming units offer the following functions:
• Reading out and changing an AS-Interface slave address
• Reading out the AS-Interface profile
• Reading out and changing the data and parameter bits
• Function check and test run.
When using a hand-held programming device, you need a
2-core
connection cable that
fits onto the AS-interface plug connector of the DRC drive unit (see the following figure).
6.8.1
X4271: AS-Interface communication interface
The following table informs about this connection:
NOTICE
Damage to the units caused by faulty installation
Possible damage to property
• The hand-held programming device may
only
be connected with the AS-Interface
plug connector via pins 1 "AS-Int" and 3 "AS-Interface –". The hand-held
programming device can be damaged if not connected properly.
Function
Connection of AS-Interface data cable
Connection type
M12, 4-pole, male, A-coded
Wiring diagram
2384154763
Assignment
No.
Name
Function
1
AS+
AS-Interface data cable (+)
2
n.c.
Not connected
3
AS
−
AS-Interface data cable (
−
)
4
n.c.
Not connected
2
1
4
3
00
I
